Site
Map • Contact
Us 中文 • English
High-Performance Power ICs and Hall-Effect Sensors
- Home
- / Products
- / Demo Boards
- / ASEK-01
- / Demo Boards
- / Products
ASEK-01: Allegro Sensor Evaluation Kit 
Bill-of-materials (PDF), Schematics (PDF)
The ASEK (Allegro Sensors Evaluation Kit) is used for programming supported Allegro Hall effect devices. It consists of the ASEK Programming Board, control software, and an optional Calibration Board (which also uses the ASEK software).
These tools allow the programming of the following Allegro devices:
- A118x: Two-Wire, Programmable, Chopper-Stabilized, Unipolar Hall-Effect Switch
- A138x: Programmable Linear Hall Effect Sensors with Analog Output Available in a Miniature Thin Profile Surface Mount Package
- A325x: Open-collector unipolar Hall-effect switch with programmable operate point
- A1373 and A1374: Very accurate linear Hall-effect sensor with programmable quiescent voltage output, sensitivity, and temperature coefficient
- ATS635/6: Back-biased unipolar Hall-effect switch
The ASEK is intended for demonstration purposes only. The boards and software should only be used for very low volume, manual production or engineering evaluations.
- Purchase ASEK-01 programming board and software
- Download ASEK Software or request CD-ROM
- Purchase Calibration Board
Requirements for installation and operation
- Microsoft® Windows® 2000, SP3 recommended; operational compatibility with Windows 98 and XP but not tested
- RS-232C interface cable (male DB9 to female DB9)
- Linear programmable power supply (+32 V, -5 V available)
Help Documents
Software and Hardware Updates
- ASEK Board Rev. 2
- ASEK software Rev. 1.6.15
- Calibration Board Rev. 2