ASEK-01: Allegro Sensor Evaluation Kit

Bill-of-materials (PDF), Schematics (PDF)

The ASEK (Allegro Sensors Evaluation Kit) is used for programming supported Allegro Hall effect devices. It consists of the ASEK Programming Board, control software, and an optional Calibration Board (which also uses the ASEK software).

These tools allow the programming of the following Allegro devices:

A118x: Two-Wire, Programmable, Chopper-Stabilized, Unipolar Hall-Effect Switch
A138x: Programmable Linear Hall Effect Sensor ICs with Analog Output Available in a Miniature Thin Profile Surface Mount Package
A325x: Open-collector unipolar Hall-effect switch with programmable operate point
A1373 and A1374: Very accurate linear Hall-effect sensor IC with programmable quiescent voltage output, sensitivity, and temperature coefficient
ATS635/6: Back-biased unipolar Hall-effect switch

ASEK-01 Software - Download with Programming Board.

The ASEK is intended for demonstration purposes only. The boards and software should only be used for very low volume, manual production or engineering evaluations.

Download ASEK Software or request CD-ROM

Requirements for installation and operation

Microsoft® Windows® 2000, SP3 recommended; operational compatibility with Windows 98 and XP but not tested
RS-232C interface cable (male DB9 to female DB9)
Linear programmable power supply (+32 V, -5 V available)

Help Documents

Customer Applications Kit Help.

Software and Hardware Updates

ASEK Board Rev. 2
ASEK software Rev. 1.6.15
Calibration Board Rev. 2